双层毛细芯对环路热管传热性能的实验分析

环路热管作为一种高效的相变传热装置,其性能与位于蒸发器和储液槽之间的毛细芯结构密切相关。为了更深入研究双层毛细芯对环路热管传热性能的影响,利用不同颗粒直径铜粉制备双层毛细芯,在毛细芯总厚度为5 mm的条件下,通过调整大粒径和小粒径层的相对厚度来改变毛细芯厚度比,对平板型蒸发器环路热管启动和变工况运行进行实验测试。实验结果表明:在同一工况下,不同厚度比的双层毛细芯启动特性存在显著差异,启动过程中出现小粒径层蒸发效率低引起的温度过冲和环路热管中气液两相流变化导致的温度振荡;同时存在一个较优的双铜层毛细芯厚度比,大粒径(180～280μm)铜层厚度为3 mm可提高蒸发效率,小粒径(56～71μm)铜层厚度为2 mm可提供足够毛细抽吸力保证环路热管稳定运行。搭载该厚度毛细芯的环路热管不仅启动速度快(125 s),而且总热阻和蒸发器壁面温度均最低,最大加热功率达到120 W(21.10 W/cm~2),对应热阻为0.17 K/W。     

Effects of molecular modifications for water splitting enhancement of BiVO4

Combined organic (molecular adsorption) and inorganic (TiO₂ passivation) modifications for enhancing water splitting efficiency of porous bismuth vanadate electrodes are tested. The catalytic activity of BiVO₄ is increased after adsorption of a newly prepared ruthenium catalyst. TiO₂ passivation and sensitization with RuP dye does not show straightforward improvements to the complex photocatalytic behaviour depending on the configuration of the (two- or three-electrode) photoelectrochemical cell, type of the experiment and sample aging. The time constant for electron transport in BiVO₄ electrodes (in the range of seconds, revealed by electrochemical impedance measurements) was found to correlate with the stable photocurrent of the cells. The femtosecond transient absorption studies confirm the negligible effects of RuP on the population of the photoexcited carriers in BiVO₄. The transient absorption studies also show that the processes responsible for the differences in photocurrents of the modified BiVO₄ samples occur on a time scale longer than the first nanoseconds.     

某型运输机飞行状态下冷凝器风道性能

以某型运输机蒸发循环制冷系统用冷凝器为研究对象，分析了运输机与直升机、小型通航飞机蒸发循环制冷系统工作环境的区别，应用Star CCM+软件进行了仿真建模，通过对冷凝器风道的流体仿真分析，阐述了飞行状态下引起蒸发循环制冷系统压力故障的原因，在此基础上提出了冷凝器风道优化方案，并应用流体仿真分析的方法，验证了优化方案的有效性，最后在该运输机上进行了试飞验证。     

基于CFD技术优化50 L发酵罐内气体分布器

通过CFD模拟技术对50L通气搅拌发酵罐内不同气体分布器的传质混合效果进行气液双相流模拟。首先对发酵罐自带气体分布器进行流场模拟,针对模拟结果提出两种改进气体分布器。结果表明:双层环形气体分布器表现出一种较理想的混合传质效果,为此类发酵罐的优化和放大提供一种有效的技术手段。     

Carborane-Containing Matrix Metalloprotease (MMP) Ligands as Candidates for Boron Neutron-Capture Therapy (BNCT)

Based on the previously reported potent and selective sulfone hydroxamate inhibitors SC-76276, SC-78080 (SD-2590), and SC-77964, potent MMP inhibitors have been designed and synthesized to append a boron-rich carborane cluster by employing click chemistry to target tumor cells that are known to upregulate gelatinases. Docking against MMP-2 suggests binding involving the hydroxamate zinc-binding group, key H-bonds by the sulfone moiety with the peptide backbone residues Leu82 and Leu83, and a hydrophobic interaction with the deep P1’ pocket. The more potent of the two triazole regioisomers exhibits an IC₅₀ of 3.7 nM versus MMP-2 and IC₅₀ of 46 nM versus MMP-9.     

低温绝热气瓶绝热性能检测时间优化分析

蒸发率是用来检测低温绝热气瓶绝热性能是否合格的一个重要指标,但是目前仍存在检测时间较长的不足。依据一维传热模型,提出了一种基于一定检测时长的优化检测方法。该方法以少于24 h的实际检测数据作为样本来获取传热系数等部分参数,并利用获取的参数预测剩余时间的蒸发流量,最终实现缩短检测时间的目的。为了验证优化方法的有效性,搭建了恒温箱实验台并进行了相关试验测试。对比结果表明,计算结果与试验值符合良好,误差在5%以内,验证了模型的可靠性与实用性。     

Moisture transfer and stress development during high-temperature drying of Chinese fir

Abstract

The knowledge of moisture content (MC) and drying stress are crucial parameters to control the drying process and maintain the quality of dried wood. Herein, we investigated the pattern of moisture transfer and stress development in Chinese fir during the high-temperature drying process. The MC in each layer of lumber was separated into bound water and free water via nuclear magnetic resonance (NMR), and the drying and residual stress were measured using prong test method. There was different MC in each layer along the thickness, resulting in an MC gradient that initially increased and then decreased, which is consistent with the trend of drying stress. The T₂₁ peak indicating bound water shifted to the left especially when MC was below the fiber saturation point, signifying that the discharge of moisture became difficult with prolonged drying time. The ratio of bound water to free water was different in each layer, indicating that the moisture transfer was different along the thickness. Furthermore, the residual stress was greater than the corresponding drying stress though the disparity reduced gradually, which suggests that the MC gradient was the largest affecting factor for drying stress at high MC stages but decreased to some extent as the drying process continued.     

三塔合一间接空冷塔换热能力与烟气扩散的数值模拟

基于CFD方法研究了环境风速对某2×350 MW机组三塔合一间接空冷塔（塔内布置两座脱硫排烟装置）空冷三角散热量和烟气扩散的影响。结果表明：空冷塔内布置脱硫排烟装置对空冷塔的进风量和空冷三角散热量的影响可忽略不计；随着环境风速的增大，两台机组运行时三塔合一和常规间接空冷塔（塔内无脱硫排烟装置）的进风量和空冷三角散热量呈现先减小后基本不变的规律，一台机组运行时三塔合一和常规间接空冷塔的进风量和空冷三角散热量呈现先减小后增加的规律；对于烟气扩散，随着环境风速的增大，SO2气体的最低扩散高度呈现先降低后基本不变的规律，SO2气体的扩散距离呈现逐渐减小的规律，且两台机组运行时SO2气体的扩散距离明显大于一台机组。     

Dietary Alcohol and Fat Differentially Affect Plasma Cholesteryl Ester Transfer Activity and Triglycerides in Normo- and Hypertriglyceridemic Subjects

Moderate alcohol consumption is associated with increased plasma high-density lipoprotein (HDL)-cholesterol concentrations and reduced risk for cardiovascular disease. Plasma cholesteryl ester transfer activity (CETA) mediates the exchange of HDL-cholesteryl ester (CE) for the triacylglycerol (TAG) of very-low-density lipoproteins. We compared the effects of oral challenges of Alcohol, saturated fat (SAT), and (Alcohol + SAT) on plasma CETA, cholesterol, nonesterified fatty acids (NEFA), and TAG among normo-triglyceridemic (NTG) and mildly hypertriglyceridemic (HTG) volunteers having a range of plasma TAG concentrations. The major changes were (1) CETA increased more after ingestion of SAT and (Alcohol + SAT) in the HTG group versus the NTG group; (2) after all three challenges, elevation of plasma TAG concentration persisted longer in the HTG versus NTG group. Plasma cholesterol was not affected by the three dietary challenges, while Alcohol increased NEFA more in the HTG group than the NTG group. Plasma TAG best predicted plasma CETA, suggesting that intestinally derived lipoproteins are acceptors of HDL-CE. Unexpectedly, ingestion of (Alcohol + SAT) reduced the strength of the correlation between plasma TAG and CETA, that is the effects of (SAT and Alcohol) on plasma CETA are not synergistic nor additive but rather mutually suppressive. The alcohol-mediated inhibition of CE-transfer to chylomicrons maintains a higher plasma HDL-cholesterol concentration, which is athero-protective, although the suppressive metabolite underlying this correlation could be acetate, the terminal alcohol metabolite, other factors, including CETA inhibitors, are also likely important.     

采用泡沫铜电极的热再生氨电池性能数值模拟

以采用泡沫铜电极的热再生氨电池（thermally regenerative ammonia-based battery，TRAB）为研究对象，建立了多孔介质内物质传输与电化学反应耦合的稳态模型，计算获得了电池性能及多孔电极内物质传输特性，并研究了电解质浓度和电极孔隙率对电池性能的影响。研究结果表明，从主流区界面到多孔电极内部，阳极氨和阴极铜离子浓度逐渐降低，存在一定的浓度梯度，而且随着反应电流的增大，浓度梯度明显增大。在一定的范围内分别增大阳极氨浓度和阴极铜离子浓度，从主流区向多孔电极内物质传输增强，电池性能均能不断提升；随着硫酸铵浓度的增大，电解质电导率增大，电池性能逐渐提升，但增幅逐渐减小。此外，多孔电极孔隙率也会影响电池性能，本研究中TRAB在电极孔隙率为0.6时获得最高的最大功率(15.3 mW)。